進口消防電磁閥_常開 NO 與常閉 NC 區別
進口消防電磁閥(Germany LIK 萊克)常開 NO 與常閉 NC 區別
Difference Between Normally Open (NO) & Normally Closed (NC) Imported Fire Solenoid Valve Germany LIK
> 核心區分:**不通電(常態)下閥門的原始位置**
> The core difference: valve position under de-energized normal condition.
一、工作邏輯 Working Logic
常閉型 NC(消防系統主流)Normally Closed
✅ 斷電 / 無火警信號:閥門關閉,管路切斷,介質不通
De-energized / No fire signal: Valve closed, pipeline shut off, no medium flow
✅ 通電(收到火警 DC24V 信號):電磁吸合,閥門打開,介質釋放滅火
Energized (DC24V fire signal received): Electromagnet pulls core, valve opens, medium released for fire suppression
✅ 斷電復位:火警消除,斷電,彈簧復位,閥門自動關閉
Power-off reset: Fire cleared, power cut, spring resets, valve closes automatically
常開型 NO Normally Open
✅ 斷電 / 無火警信號:閥門保持打開,管路通流
De-energized / No fire signal: Valve stays open, pipeline unobstructed
✅ 通電:電磁力動作,閥門關閉,切斷介質
Energized: Electromagnetic force actuates, valve closes to cut off medium
✅ 斷電復位:斷電后,閥門自動打開
Power-off reset: Valve opens automatically after power loss
二、結構差異 Structural Difference
1. 復位彈簧裝配方向相反,閥芯初始受力方向不同。
The reset spring assembly direction is opposite, the initial force direction of spool differs.
2. LIK 萊克先導式消防電磁閥:
LIK pilot fire solenoid valve:
- NC:常態彈簧壓緊主閥密封;通電先導腔泄壓,主閥開啟
NC: Spring presses main valve seal at normal state; pilot chamber pressure relief when energized to open main valve
- NO:常態主閥保持開啟;通電先導腔建壓,壓緊主閥關閉
NO: Main valve remains open at normal state; pilot chamber pressurized when energized to close main valve
3. 密封件、閥座結構基礎一致,線圈規格可通用(DC24V/AC220V,防水 / 防爆可選)。
Seals and valve seat structure are basically the same, coil can be shared (DC24V / AC220V, waterproof /explosion-proof optional).
三、適用場景 Application Scenarios
常閉 NC(消防項目首選)
- 雨淋系統、預作用系統、消防水炮、水幕、泡沫滅火主管控制
Deluge system, pre-action system, fire monitor, water curtain, foam fire main pipeline control
- 平時管網嚴禁誤噴水,只有火警信號才開啟釋放滅火劑
No accidental water spray under normal condition; only open upon fire alarm signal
> 消防規范絕大多數場景推薦選用 DC24V 常閉型
> DC24V NC type is recommended for most fire protection projects according to fire codes
常開 NO(特殊工況)
- 消防旁路、泄放管路、緊急泄壓管線;斷電時必須保持通路
Fire bypass, discharge pipeline, emergency pressure relief line; flow must remain open during power failure
- 需要**正常持續通介質,火警通電切斷管路**的特殊消防工藝系統
Special fire process system requiring continuous medium flow normally and pipeline cut-off upon fire alarm
> 普通噴淋、雨淋系統**不推薦常開型**,停電會造成誤噴事故
> Not recommended for standard sprinkler or deluge system; power failure may cause accidental water discharge
四、優缺點對比 Comparison
常閉 NC
Advantages 優點:
1. 常態關閥,停電不會自動噴水,安全性高,杜絕誤噴
Valve closed normally, no automatic water spray on power failure, high safety, prevent accidental discharge
2. 符合國內消防自動滅火系統設計習慣,驗收更容易
Comply with domestic fire system design standard, easy project acceptance
Disadvantages 缺點:
火災觸發期間線圈需要持續通電維持開啟,長時間通電會產生功耗。
Coil needs continuous power to keep open during fire event, consumes power.
常開 NO
Advantages 優點:
常態無需供電保持通路;僅需要切斷介質時才通電。
No power required to keep flow normally; energized only when medium cut-off is needed.
Disadvantages 缺點:
1. 一旦系統斷電,閥門自動全開,極易發生誤噴,風險高
Valve fully open automatically once power fails, high risk of accidental discharge
2. 普通消防系統很少采用,項目報審需要單獨論證
Rarely used in conventional fire systems, separate demonstration required for project approval
五、選型關鍵提醒 Selection Notes
1. 常規自動滅火:優先 **NC 常閉 DC24V**(LIK 萊克消防電磁閥標配)
For standard automatic fire suppression: NC DC24V is preferred (standard model of LIK fire solenoid valve)
2. 選型前必須確認消防主機輸出信號邏輯,信號類型與閥門類型匹配
Confirm fire alarm control panel output logic before ordering, match signal type with valve type
3. 常開 NO 用于消防必須評估斷電風險,提前做好防誤噴措施
If NO type is adopted for fire system, evaluate power failure risk and take anti-spray measures
4. LIK 萊克兩種型號均可選:黃銅 / 304 不銹鋼閥體、法蘭 / 螺紋、防爆線圈版本
Both NO and NC versions available for LIK: brass /304SS body, flange /thread, explosion-proof coil options
六、快速區分簡易口訣
NC 常閉:**不通電關,通電開,火警來了才噴水
NO 常開:**不通電開,通電關,斷電自動通介質